XAL Engeineering Blow, Fill - Seal Machine - 2
|
 |
| |
You are making an offer on a XAL Engeineering Blow, Fill - Seal Machine - 2 located in India. This lot is being sold "as is, where is." We recommend that you contact an EquipNet sales representative to set up your own inspection.
Number of Cavities for 3.0ml container 25 Cavities
Number of Cavities for 5.0ml Vials 20 Cavities
Capacity out put / Hr: 3.0ml container 5400 container / Hr. and 5.0ml Container 4000 container / Hr.
Extruder Screw Diameter: 55 mm
Screw Ratio: 24:1
Screw Output: 125 Kgs / Hr.
Type of plastic which can be extruded: All blow molding grades of LDPE.
Connected Heater Load: 20 Kw
No of Parision Extruded: 4 Nos.
Electrical Power: 3PH , 440V, 50Hz.
Total Connected Load: 75KW
Utility Connections below
Compressed Air: 500NL / min
Chilled water for Molds: 2.0m3 / hr. ( Approx ) at 10-12 deg. C
Cooling water for Hydraulics system: 1.5m3 / hr.
Molds included with machine: None
Year of Purchase: Jan-2001
- Manufacturer XAL Engineering Pvt Ltd.
- Estimated Shipping Weight 0 LBS
- Length
- Width
- Height
- Removal Difficulty EASY
- Requires rigging or removal UNKNOWN
- Requires a flatbed truck UNKNOWN
- Level of shipment preparation necessary UNCRATED/LOOSE
Contact Information
If you need further information, please contact our Sales Department at 888.371.6555, outside USA at +1.781.821.3482, or click here to send us a message, or by email to sales@EquipNet.com
Payment Methods:
Certified Check, Bank Check, Company Check w/Bank Guarantee, or Wire Transfer
Crating, Rigging, and Shipping Info:
Buyer is responsible for all crating and shipping charges. EquipNet can furnish a quote upon request. Please contact sales@equipnet.com.
Location:
India
Dimensions: 0x0x0 FT
Disclaimer
Please note: All listing descriptions take precedence over what may be showing in the photo. If you have any questions at all on this listing, please contact EquipNet.
|
|
|
