Becomix RW-250 Vacuum Mixer - Homogenizer Becomix has all the tools that are required in the industry for the preparation of creams, ointments, emulsions and all kinds of products containing different phases, and to be able to join them in an adequate way under the GMP requirements, with low energy and time consumption.
Temperature Control and management cabinet:
Vertical, multistage centrifugal pump with suction and discharge ports on same the level: Grundfos (CRI1-7 A-FGJ-I-E-HQQE). 0,75 kW, Hmax 63.4 m, H 48.8 m, Q 2.2 m3/h, f 60 Hz, 3474 (min-1).
Control Valves: Spirax Sarco PN9126E samrt positioner, Press Max 6 (87 psi).
Vacuum Pump: Sterling Fluid Systems type LEMA150, 1800 RPM, 7.5 HP, Max compression over pressure 0,3 bar, Max admisible pressure diferrence 1,1 bar, Hydraulic test (over pressure) 3 bar, Max gas temperature dry (100C) saturated (50C), Volume up to shaft level 4 Lt.
Control valves: PF6 stainless steel piston actuated On/Off valves. Fluid temp 180C, Actuator air supply 8 bar.
Agitation system of crossed anchors and scrapers in Teflon with springs, which are located in an intercalated way avoiding dead points, and guaranteeing a constant and uniform energy exchange of heating/cooling, in short times. Agitator motor: Flender Himmel 6,6 kW, 60 Hz, 260/450V, 21,2/12m2 Amp, 1740 RPM.
Pressure vessel: capacity 4,1 Lt, Max pressure 3 bar. Allowable temperature 133-151C, Allowable presure 4 bar, capacity 380 Lt
Homogenizer rotor crown motor: Emod type 132M-4/2, 260V, 20,5/25 Amps, 6,4/7,8 kW, 1740/3490 RPM, 60 Hz.
Electrical control and power cabinet: Includes PLC Siemens Simatic S7-300, Siemens 6EP1 336-3BA00 Power supply. Schneider Electric ATV312HU75N4 Variable speed drive 7.5kW-18kVA-269W-380-500V- 3 ph. Schneider Electric ATV312HD11N4 Variable speed drive 11kW-15HP-380-500V.
Temperature measurement: The product temperature is measured by a temperature transducer installed on the homogenizer. It is connected to an indicating device located in the control cabinet (0-150C).
Does not include Acuosa Tank, Oleosa tank and chiller.
Includes three boxes with spare parts such as (gasket, rotors and flow meters).
Includes blueprints, technical sheets and engineering catalogs.