Estufa para Laboratórios Fisher Scientific

The Fisher Scientific Isotemp OV702F (Cat. No. 13-247-750F) is the large-capacity model of the Isotemp Premium 700 Series forced-air laboratory oven, used for drying, curing, sterilizing and general heating of glassware, samples and small parts. The oven has a 5.0 cubic foot chamber measuring approximately 18 x 18 x 26.5 inches and a published operating range of 50 to 275 degrees C, with mechanical (forced-air) convection for temperature uniformity and faster recovery after door openings. Control is by the front-mounted Isotemp Oven microprocessor panel seen in photo 3, with a red LED temperature display in degrees C, Menu and Set keys, Increase/Decrease arrows, Program, Alarm and Heat indicators, and an On/Off rocker switch. The nameplate in photo 4 reads Model No. OV702F, Cat. No. 13-247-750F, Serial No. 2038091038802, 120 volts, 15.5 amps, 60 Hz, and carries a cULus Listed Laboratory Equipment mark. The interior shown in photo 2 is stainless steel with slotted side racks and two wire shelves installed, plus the overhead temperature sensor and floor air-distribution plate. Aluminum blocks/fixtures were sitting on the upper shelf when the photograph was taken; they are not represented as part of the sale. The unit is a freestanding bench-top cabinet with an outer housing approximately 25 x 28 x 34 inches, a latching single door with lever handle, and a standard 120 V line cord. The oven was photographed in place on a laboratory bench at a biopharmaceutical facility and carries a third-party preventive-maintenance/calibration service sticker and facility asset tags on the front panel. No operating hours, calibration status or functional test results were recorded at the site visit.