EquipNet: Wanted Equipment

Wanted Equipment - View equipment by type, industry, and location

Occasionally EquipNet has a customer that is looking for a very specific piece of equipment that we do not have listed on our extensive MarketPlace. When this happens we use all our resources to search high and low to meet our client’s needs.

Below is the list of current wanted equipment. If you have a piece on this list, please upload your equipment information using our Post It Now platform or contact an EquipNet Sales Representative and we will post it for you. If you are searching for your own wanted equipment, contact us today!


Showing 1 - 50 of 344 listings


Show:
« Page 1 of 7 »
Floor Scrubber

Floor scrubber wanted specifically in the UK. Manual or ride on.

Category:
Floor Scrubbers
Manufacturer:
Uncategorized
Pres

Cold Press Juice Press

Category:
Presses
Manufacturer:
Uncategorized
IMA CP 18 Case Packer

Looking for a CP 18 case packer with top and bottom tape closure ( Not Glue)

Category:
Case Packers
Manufacturer:
IMA
Year:
2005 - 2016
Evaporator

Pilot-Sized Falling Film Evaporator

Category:
Evaporators
Manufacturer:
Uncategorized
Sheeter

Automatic Dough Sheeter, prefer Rondo

Category:
Sheeters
Manufacturer:
Uncategorized
Silo

Looking for 6 x 50 tonne storage silos for our raw HDPE - for purchase only in UK and Europe. For transport reasons, specifically looking for tall rather than short and wide.

Category:
Silos
Manufacturer:
Uncategorized
Stainless Steel Kettle

40-80 gallons capacity. Needs mixing capability if possible (or capable of adding lightning mixer). Limited to 220/240 VAC. Would prefer bottom empty manifold for pumping to our holding tank.
Would need to be able to heat from 40 C to 75 C in roughly 40 – 50 minutes.

Category:
Stainless Steel Kettles
Manufacturer:
Uncategorized
Stainless Steel Kettle

Electric or propane. 60 or 80 gallon. Must have CSA certification. Single phase power only.

Category:
Stainless Steel Kettles
Manufacturer:
Uncategorized
Extractor

supercritical extractor needed ; preferably x 3 cannister system, 20-25l each in capacity, corresponding seal to pump, to use ethanol solvent (need to pump ethanol), must have a regulator inside each vessel for the right fraction, stainless steel 316 grade.

Category:
Extractors
Manufacturer:
Uncategorized
Heat Tunnel

24" - 36" electric inline heat tunnel, over conveyor design

Category:
Heat Tunnels
Manufacturer:
Uncategorized
Check Weigher

Check Weigher, max 3' wide, with reject, belt only

Category:
Check Weighers
Manufacturer:
Uncategorized
Blender

150 cu ft jacketed paddle or ribbon blender

Category:
Blenders
Manufacturer:
Uncategorized
Yamato 510 Scale

2 Yamato scales, ten head with memory buckets with a 5 Liter total volume, the part number will have 510 in it.

Category:
Scales
Manufacturer:
Yamato
Storage Tote

10 Stainless Steel Liquid Totes, 300 gallon or 1,200 liter

Category:
Storage Totes
Manufacturer:
Uncategorized
Capper

Inline run through capper, Pharma quality

Category:
Cappers
Manufacturer:
Uncategorized
Melter

Chocolate Melter, 1500-4000 lb capacity

Category:
Melters
Manufacturer:
Uncategorized
Filler

Leepack or similar pre-made pouch filler with zipper

Category:
Fillers
Manufacturer:
Uncategorized
Vertical Cartoner

Vertical cartoner with scale, auger or volumetric filler for rice, up to 1.4Kg box

Category:
Vertical Cartoners
Manufacturer:
Uncategorized
Vertical Form Fill Seal Machine

Customer needs VFFS that can be used to fill a heated product consistency of honey. Web width 16-25 inches, 40 cycles per minute.

Category:
Vertical Form Fill Seal Machines
Manufacturer:
Uncategorized
Capper

trigger feeder, inserter capper

Category:
Cappers
Manufacturer:
Uncategorized