The Getinge Autoclave is designed for the sterilization of porous or laboratory materials, which are capable of withstanding seam at high temperatures in excel of 100°C. The Autoclave is supplied with the following process cycles and test facilities: 1. Vacuum Cycle 2. Leak Test 3. WarmUp and ALRT combined Mechanical Enclosure Fascia Panels the sterilizer is a recessed installation with fascia panels to the loading side only. Material: Stainless steel 1.4301 (AISI 304). Front surface texture: Tetra polished Ra< 1,2 micrometer Thickness 1.0 mm. Loading area / Plantroom area Barrier There is no requirement for a barrier. Pressure Vessel Loading Height: 300 mm from floor to the chamber bottom. Chamber Internal Dimensions Useable width 700 mm Useable height 1450 mm Useable depth 1350 mm Construction: Cross section: Rectangular Material: AISI 316L acid proof stainless steel Design pressure: 3 bar (g) & full vacuum Design temperature: 143 °C Welds: Robotic or semi-automatic whenever possible Internal Chamber and Ports Finish internal surface ground and polished to a high lustre Internal Ra value 0.6 microns 1 Door Design: Fully automatic, horizontal sliding Opening and closing: Automatic button controlled Door operation: Pneumatic motor Door safety: Stops and reverses if obstructed. Door close isolation keyswitch to prevent door closing if access to chamber is required. Internal door surface: AISI 316L stainless steel Door pins: AISI 316 stainless steel Media (Utility) Requirements Please refer to the installation drawing for details of sizes & consumptions. Requirements: Steam Compressed Air Supply Potable Water Supply Cooled Water Supply Condense